698043
3
Zoom out
Zoom in
Previous page
1/140
Next page
3
1. SAFETY WARNING
The minimum distance between the hob surface on which the pans stand
and the lower part of the hood must be 65 cm, unless otherwise speci ed
in the installation instructions. If the hob installation instructions specify a
greater distance, it must be taken into account.
The air collected must not be conveyed into a duct used to blow off
smokes from appliances fed with an energy other than electricity (central
heating systems, thermosiphons, water-heaters, etc.).
Comply with the of cial instructions provided by the competent authorities
in merit when installing the disposal duct. In addition, exhaust air should
not be discharged into a wall cavity, unless the cavity is designed for that
purpose.
The room must be well aerated in case a hood and some other heat
equipment fed with an energy other than electricity (gas, oil, coal heaters,
etc) operate at the same time.
In fact the intake hood, disposing of air, could create a vacuum in the room.
The vacuum should not exceed 0,04mbar. This prevents the gas exhausted
by the heat source from being intaken again. It is therefore advisable to
ensure the room contains air taps able to ensure a steady ow of fresh air.
Check the data label inside the appliance; if the symbol (
) is printed, read
the following: this appliance has such technical particulars that it belongs
to class II insulation, therefore it must not be earthed.
Check the data label inside the appliance; if the symbol ( ) is NOT prin-
ted, read the following: ATTENTION: This appliance must be earthed.
When making the electrical connections, check that the current socket has
a ground connection.
When making the electrical connections, check that the voltage values
correspond to those indicated on the data plate inside the appliance itself.
In case your appliance is not tted with a supply cord and a plug or with
other means for disconnection from the supply mains having a contact
separation in all poles that provide full disconnection under overvoltage
category III conditions, that means for disconnection must be incorporated
in the xed wiring in accordance with the wiring rules. If your unit features
a power lead and plug, position this so the plug is accessible.
Always switch off the electricity supply before carrying out any cleaning
or servicing operations on the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly quali ed persons in order to avoid a hazard.
ENGLISH
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for AEG DPB3931S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of AEG DPB3931S in the language / languages: All languages as an attachment in your email.

The manual is 10,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info