799452

Adler AD 1299 Manual

4
Zoom out
Zoom in
Previous page
1/80
Next page
4
Press“B” key once / twice / thrice / the fourth time, then the indicator light is under 60℃ / 70℃ / 80℃ / 90℃ condition with green / blue /
yellow / purple LED light. This means that it will stop heating when the water temperature reaches 60℃ / 70℃ / 80℃ / 90℃
Press the „A” key for 3 seconds, with the buzzer sends out „di” sound, it starts running the function of hest insulation. The LED light
will be shining with red light, while after the water boils, the kettle will keep the water temperature for 2 hours with the indiactor light
shining. Durning the 2 hours heat insulation function runnining, it will go on heating when the temperature arrives at 85 ℃
KEEP WARM FUNCTION 100℃
WATER BOILING 60℃ - 90℃
9. Regularly remove limestone sediment inside the kettle. Sediment may cause overheating of the kettle, shorten life cycle and
cancel guarantee. Use mixings available in household stores or apply citric acid.
4. After boiling water the kettle will automatically switch off.
29. Children aged 3 to 8 years old can enable and disable the device only when it is in
its normal position of use, they are supervised or instructed on the safe use and
understand the resulting risks. Children aged 3 to 8 years old can not connect device,
operate, clean or maintain.
DESCRIPTION
1. Fill the kettle with water. Make sure that heating plate is fully immersed in water.
8. After boiling, time demanded for the thermostat to be ready is 2 minutes. After this time kettle can be switched on again.
BASICAL OPERATION:
5 - base 6 - filter 7 - control panel 8 - tea infuser 9 - indicator lamp
SINGLE BOILING UP TO 100℃
After the water boils, indicator turns off and the buzzer sends out a “di” sound at the same time.
7. Keep lid closed during boiling process. Or the kettle won't automatically switch off.
11 When the water is heated to the appropriate temperature, device signals this with one beep.
2. Place the appliance on the flat, even and heat resistant surface.
1 - plastic lid 2 - handle for opening the lid 3 - housing 4 - handle
3. Plug the kettle to the 220-240V ~50/60Hz mains, press ON/OFF (A) switch. Indicator lamp will light.
BEFORE FIRST USE: Fill up the kettle with water, boil and pour. Repeat three times. To remove possible scent of manufactory,
please boil few times water.
USING THE ELECTRIC KETTLE
12. The kettle is an electrical device and it is not designed to hold water or other liquids. Before each use, fill the kettle with fresh
water above the minimum and below the maximum level.
10. Switching empty kettle, or with insufficient level of water, will cause automate switching off the kettle. Wait till cool down the
kettle, pour enough water and after few minutes switch the kettle on.
Press the “A” key briefly, with the sound “di.”, it starts working.
ADVANCED OPERATION:
6. The kettle can manually be switched off in any time by ON/OFF (A) switch.
5. Before taking the kettle out of the base make sure it is switched off.
kettle or lid. Do not open the lid during boiling in kettle or immediately after boiling,
because steam coming out of lid can cause burns.
21. Move the kettle only by holding it by handle..
23. Never switch on kettle without water.
22. Never fill kettle above MAX level and below MIN level. It may cause damage of
kettle.
25. Descale your kettle regularly. Using kettle with heating element covered by scale
may cause damage.
24. Never use kettle without filter or with open cover (automatic shutdown will not work).
26. Do not use aggressive detergents to wash the kettle housing - they can damage the
kettle or remove the markings.
27. The device is not designed to work with external schedulers or separate remote
control system.
28. Do not wash the base of the kettle directly in the water, just wipe with a dry cloth.
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Adler AD 1299 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Adler AD 1299 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 10.08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info