If a fault occurs during operation, the system locks out and the display starts to ash. The rst character is an “E” or “b” and the following two indicate the code
of this fault, as indicated in the table below.
To unlock the system:
• Press "RESET" on the MCBA interface.
• If the fault repeats, check the error codes below to solve the problem.
Codes
Fault descriptionFault solutions
E 00
Abnormal flame signal detected
1. Check the wiring (short circuit in the 24 V wiring)
2. Check the electrode
3. Replace the MCBA (water damage)
E 02
No flame presence after five start-up attempts
1. Check the ignition wiring
2. Check the electrode and its position
3. Check the burner gas level
E 03
Gas valve or triac error Replace the rectifier or the gas valve
E 04
Durable lockingPress “RESET”
E 05
No flame detection or poor feed current quality
1. Check the electrode gap
2. Check resistance k of the electrode cable
3. Stabilisation of the current
E 06
Detection of an Input errorCheck the Input and press “RESET”
E 07
Gas valve relay errorIf the problem persists after two “RESET” attempts, replace the MCBA
E 08
The air pressure switch did not closeCheck the air pressure switch
E 11
EPROM errorIf the problem persists after two “RESET” attempts, replace the MCBA
E 12
Max input thermostat open or 24 V fuse has blown
1. Check the limit thermostat
2. Check the 24 Volt fuse of the MCBA
3. Link 12-13 missing
E 13
Internal errorIf the problem persists after two “RESET” ATTEMPTS, replace the MCBA
E 14
Water in the 24 Volt circuitCheck the 24 Volt circuit and dry if necessary [sensors, terminal, etc.]
Unable to reset (E 14) fault on Heatmaster 71 what are the relevant checks before changing board. pumps ok fans ok resistance reading on sensors ok
Submitted on 24-6-2021 at 18:13
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for ACV HeatMaster at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of ACV HeatMaster in the language / languages: English as an attachment in your email.
The manual is 2,11 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.