692215
16
Zoom out
Zoom in
Previous page
1/19
Next page
Functions and settings:
16
Settings
Note: the jumpers [LK2] [LK9] can only be reached if the inner housing has been opened with two
screws (Fig. 2 No 12). [LK1] (Fig. 2 No 10) can be reached by opening the terminal cover.
The terminals can all be reached by opening the terminal cover.
[LK1] SAB/SCB
SAB (default setting):If activated, the whole power supply is applied to operate the sounder from
the alarm panel
SCB:If activated, the whole power supply to operate the sounder is fed through the internal battery
[LK2] TAMPER RTN
This jumper allows you to select between a negative ve (default setting) or a positive +ve
notification via the tamper contact.
[LK3] TRIG/SIREN
This jumper allows you to select the type of trigger for the acoustic alarm. ve (default setting) or
+ve.
[LK4] STROBE
This jumper allows you to select the type of trigger for the visual alarm (flashing light). ve (default
setting) or +ve.
[LK5] Circuit monitoring
Note
This setting is mandatory for EN Grade 3 installations.
When it is activated, the device monitors the integrity of the connection cables for the acoustic
alarm, and the visual alarm by evaluating resistor values. These resistors are applied on the
opposing signal, and are needed to trigger the acoustic or visual alarm.
Example: If the sounder is controlled by a negative signal ve (default setting), the monitoring
resistor is connected between the positive supply voltage and the signal wire in the alarm panel. If
the signal wire for the acoustic alarm is then interrupted or removed, the error output opens the
circuit. If the visual alarm’s control is interrupted or removed, the flashing light starts. The error
output is not opened in this case.
Note
Attaching the resistors in the device yourself, does not comply with the requirements of
EN Grade 3.
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Abus AZSG10000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Abus AZSG10000 in the language / languages: English as an attachment in your email.

The manual is 1,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Abus AZSG10000

Abus AZSG10000 Usermanual and installation guide - German - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info